[Starlingx-discuss] Duplex Mode standby controller not coming up

Rajesh Jha Rajesh.Jha at rsystems.com
Mon Nov 19 06:50:50 UTC 2018


Hi,


  On the latest iso from mirror

http://mirror.starlingx.cengn.ca/mirror/starlingx/centos/2018.10/20181110/outputs/iso/


When I run the Duplex mode, the standby controller is not coming up.  Its state is coming as inTest. Screen shot attached.


Best Regards,

Rajesh Jha


The information contained in this e-mail and any accompanying documents may contain information that is confidential or otherwise protected from disclosure. If you are not the intended recipient of this message, please immediately alert the sender by reply e-mail and then delete this message. Any dissemination, distribution or other use of the contents of this message by anyone other than the intended recipient is strictly prohibited. R Systems has taken every reasonable precaution to minimize the risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.starlingx.io/pipermail/starlingx-discuss/attachments/20181119/764fe17a/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: failed_standby_controller_duplex.png
Type: image/png
Size: 63345 bytes
Desc: failed_standby_controller_duplex.png
URL: <http://lists.starlingx.io/pipermail/starlingx-discuss/attachments/20181119/764fe17a/attachment-0001.png>


More information about the Starlingx-discuss mailing list