Hi Abhijit, Please try following commands on controller-0: source /etc/platform/openrc OAM_IF=enp2s1 system host-if-modify controller-1 $OAM_IF -c platform system interface-network-assign controller-1 $OAM_IF oam system interface-network-assign controller-1 mgmt0 cluster-host controller-1 is not configured at that point and system command normally be activated on active controller. Thanks, Shigeru From: Abhijit Deodhar <abhideodhar@gmail.com> Sent: Monday, April 6, 2020 3:25 PM To: starlingx-discuss@lists.starlingx.io Subject: Re: [Starlingx-discuss] StarlingX install question Forgot to mention that I tried doing this step to enter the admin mode, but the openrc script doesnt seem to exist on controller-1 So I am not sure how to proceed. Please advise. ~Abhijit On Mon, Apr 6, 2020 at 11:44 AM Abhijit Deodhar <mailto:abhideodhar@gmail.com> wrote: Hi, I am trying to install StarlingX on virtual standard with controller storage configuration. I am following the steps mentioned in this document: https://docs.starlingx.io/deploy_install_guides/r3_release/virtual/controlle... I reached the step where 2 controllers and 2 workers are up and running. Now I am confused with "configure controller-1" step. https://docs.starlingx.io/deploy_install_guides/r3_release/virtual/controlle... I see an error while doing this step on controller-1: I tried using sudo to repeat the step: Can someone please help me with this step to proceed with the installation? Regards Abhijit