Hi Barton,

Another question: The last step of the distributed cloud guide  says to add a route from the subcloud management network to the central cloud management network. Is this done AFTER I unlock the subcloud active controller or before?

I’m approaching the end and want to make sure I do everything correct.

Thanks

Owen

From: Wensley, Barton
Sent: Thursday, January 28, 2021 8:24 AM
To: Owen Yuen; starlingx-discuss@lists.starlingx.io
Subject: RE: Cannot configure controller-0 on subcloud after bootstrapping from central cloud

[External Email]

Owen – see my comments below…

Bart

From: Owen Yuen <OwenYuen@cmail.carleton.ca>
Sent: Wednesday, January 27, 2021 10:04 PM
To: starlingx-discuss@lists.starlingx.io
Subject: [Starlingx-discuss] Cannot configure controller-0 on subcloud after bootstrapping from central cloud

[Please note: This e-mail is from an EXTERNAL e-mail address]

Hi all,

I’m a student so please bear with me if my questions are rudimentary.

I’m trying to setup a AIO duplex distributed cloud setup with one central cloud and one subcloud. I’ve managed to bootstrap the subcloud from the central cloud successfully and the next steps says to continue the installation from the AIO duplex guide starting from “Configure controller-0”.

On step 2, I need to run system commands but all of them require the host to be unlocked. I’m not able to unlock the host either since I’m on the host itself. I assume these steps are done on the subcloud controller-0 correct?

[Bart] Yes - these steps are done on the subcloud controller-0. They are done BEFORE you unlock the subcloud controller – you will see that following these steps will eventually lead to unlocking the subcloud controller.

Any help will be appreciated.

Thanks

Owen