Hi Jaewook: Are you using iso built by yourself ? or taking iso directly from cengn? From: Jaewook Oh [mailto:jwoh95@dcn.ssu.ac.kr] Sent: Thursday, February 28, 2019 9:30 AM To: Sun, Austin <austin.sun@intel.com> Cc: starlingx-discuss@lists.starlingx.io Subject: Re: [Starlingx-discuss] Duplex PXE Booting seems failed Hi Austin, I thought I had already replied to the mail on 22, but it seems there were some mistakes. Here are the information. 1. - Here is the spec Intel(R) Xeon(R) CPU D-1557 @ 1.50GHz RAM : 32GB (Is this the problem? I already saw for the controller 64GB RAM is needed, but I'm not sure, cause the installation was just stuck literally, SSD : 500GB SuperMicro - Bios Setting: I enabled and disabled as the instruction said. And at first try, I didn't used UEFI, after failure, I changed it into UEFI, but the result was same. I enabled VTx/Iommu enable or not ? 2. I used bare metal one.. however when I pressed the buttons, nothing happened. And the controller-1 is just stopped as I said before. Thank you for helping me :) Best Regards, Jaewook. 2019년 2월 28일 (목) 오전 10:12, Sun, Austin <austin.sun@intel.com<mailto:austin.sun@intel.com>>님이 작성: Hi Jaewook: 1. could you share the hw info for controller-1 ? and check bios setting ? is it using UEFI ? VTx/Iommu enable or not ? 2. Could you try access controller-1 and press Alt+F10 to see any log if the system is bare metal ? Thanks. BR Austin Sun. From: Jaewook Oh [mailto:kyle.oh95@gmail.com<mailto:kyle.oh95@gmail.com>] Sent: Friday, February 22, 2019 2:54 PM To: starlingx-discuss <starlingx-discuss@lists.starlingx.io<mailto:starlingx-discuss@lists.starlingx.io>> Subject: [Starlingx-discuss] Duplex PXE Booting seems failed Hello StarlingX Team, I finally solved the horizon error, the port number was different. I don't know why the port was changed, but anyway the port number was 8080, not 80. But I'm now facing new obstacles, Duplex PXE Booting. I succeed to connect PXE mode, but no more process.. In Controller-0, I can find below result, [image.png] And another node that should've been controller-1, shows below letters on the display. 1) All-in-one Loading rel-19.01/installer-bzImage......... Loading rel-19.01/installer-initrd............................................................................ready. I waited this task for a day, but no changes. Any help would be very appreciated. Best Regards, Jaewook. ================================================ Jaewook Oh (오재욱) IISTRC - Internet Infra System Technology Research Center 369 Sangdo-ro, Dongjak-gu, 06978, Seoul, Republic of Korea _______________________________________________ Starlingx-discuss mailing list Starlingx-discuss@lists.starlingx.io<mailto:Starlingx-discuss@lists.starlingx.io> http://lists.starlingx.io/cgi-bin/mailman/listinfo/starlingx-discuss -- ================================================ Jaewook Oh (오재욱) IISTRC - Internet Infra System Technology Research Center 369 Sangdo-ro, Dongjak-gu, 06978, Seoul, Republic of Korea Tel : +82-2-820-0841 | Mobile : +82-10-9924-2618 E-mail : jwoh95@dcn.ssu.ac.kr<mailto:jwoh95@dcn.ssu.ac.kr> ================================================
