Hi Himanshu, If I remember correctly, this network won’t be active until is actually being used by the VMs. So, you can go on. In addition, the following 2 steps are important, FYI. # create a port for PCI-Passthrough # net-testpci is supported by “providenet-b” openstack port create --network net-testpci --vnic-type direct-physical pt_port # create VM by specifying the network with which the pt_port is attached. openstack server create --flavor <flavor_name> --image <vm_image_name> --nic net-id=net-testpci pcipt_vm regards, Yong From: Himanshu Goyal <himanshugoyal500@gmail.com> Date: Wednesday, 30 January 2019 at 3:44 PM To: "Hu, Yong" <yong.hu@intel.com> Cc: "starlingx-discuss@lists.starlingx.io" <starlingx-discuss@lists.starlingx.io> Subject: Re: [Starlingx-discuss] PCI - Passthrough Interafce on VM Thanks Yong, PCI Network has been created after given commands, But In GUI it shows as status DOWN, tried with compute lock & unlock also. [image.png] Please suggest which logs we can check. Regards, Himanshu Goyal On Tue, Jan 29, 2019 at 10:58 AM Hu, Yong <yong.hu@intel.com<mailto:yong.hu@intel.com>> wrote: On step #2, “--type” should be “vlan”. On step #3, “-nt” option was removed for a while, you might use “-c” (meaning “The class of the interface”), as follows: $ system host-if-modify -c pci-passthrough -p providernet-b compute-0 ens513f1 Using “Horizon” is another convenient way to perform these operations. From: Himanshu Goyal <himanshugoyal500@gmail.com<mailto:himanshugoyal500@gmail.com>> Date: Tuesday, 29 January 2019 at 1:14 PM To: "starlingx-discuss@lists.starlingx.io<mailto:starlingx-discuss@lists.starlingx.io>" <starlingx-discuss@lists.starlingx.io<mailto:starlingx-discuss@lists.starlingx.io>> Subject: [Starlingx-discuss] PCI - Passthrough Interafce on VM Hi, I built a setup with controller & compute machine. Able to spawn VM with flat network, But I need one PCI-Passthrough interface also on VM. Please suggest the steps to create vm with PCI-Passthrough NIC. Currently I'm following the below steps for creating pci-passthrough network: Step1: system host-lock compute-0 step2: neutron providernet-create pci_net --type flat step3: system host-if-modify -m 1500 -n pci_0 -p "pci_net" -nt pci-passthrough compute-0 ens513f1 step3 is giving wrong command error, can you please provide me the correct commands for the same. or if there is any other way to configure that. Regards. Himanshu Goyal
