Ok, I tried it from controller-0 and that step worked. But now I am stuck at the next step: [image: image.png] Since the step failed, I tried to repeat it. But I get an already configured error as shown below: [image: image.png] Please advise on how to proceed further? Thank you Abhijit On Mon, Apr 6, 2020 at 12:23 PM Yoshida, Shigeru < Shigeru.Yoshida@windriver.com> wrote:
Hi Abhijit,
Please try following commands on controller-0:
source /etc/platform/openrc
OAM_IF=enp2s1
system host-if-modify controller-1 $OAM_IF -c platform
system interface-network-assign controller-1 $OAM_IF oam
system interface-network-assign controller-1 mgmt0 cluster-host
controller-1 is not configured at that point and system command normally be activated on active controller.
Thanks,
Shigeru
*From:* Abhijit Deodhar <abhideodhar@gmail.com> *Sent:* Monday, April 6, 2020 3:25 PM *To:* starlingx-discuss@lists.starlingx.io *Subject:* Re: [Starlingx-discuss] StarlingX install question
Forgot to mention that I tried doing this step to enter the admin mode, but the openrc script doesnt seem to exist on controller-1
[image: image.png]
So I am not sure how to proceed.
Please advise.
~Abhijit
On Mon, Apr 6, 2020 at 11:44 AM Abhijit Deodhar <abhideodhar@gmail.com> wrote:
Hi,
I am trying to install StarlingX on virtual standard with controller storage configuration. I am following the steps mentioned in this document:
https://docs.starlingx.io/deploy_install_guides/r3_release/virtual/controlle...
I reached the step where 2 controllers and 2 workers are up and running. Now I am confused with "configure controller-1" step.
https://docs.starlingx.io/deploy_install_guides/r3_release/virtual/controlle...
I see an error while doing this step on controller-1:
[image: image.png]
I tried using sudo to repeat the step:
[image: image.png]
Can someone please help me with this step to proceed with the installation?
Regards
Abhijit