Hi, Good that you could resolve config_controller issue. I am not sure if you can avoid/skip extra configuration for hosts you don’t want during config_controller. I think you need to follow the installation steps normally but provision only the host you want to use. Yesterday I asked to my team and it is possible to deploy 1 controller and 1 compute only, please refer to https://github.com/xe1gyq/starlingx/blob/master/ControllerStorage.md To configure cinder on controller-0 you need to have a partition with space available to be added to cinder-volume. By default should be two partitions on each host, one with available space. Regards. Juan Carlos Alonso From: Himanshu Goyal [mailto:himanshugoyal500@gmail.com] Sent: Thursday, January 17, 2019 11:16 PM To: Alonso, Juan Carlos <juan.carlos.alonso@intel.com> Cc: starlingx-discuss@lists.starlingx.io Subject: Re: [Starlingx-discuss] Deployment Option Thanks Juan, Error is resolved after again boot the server. The reason for that my management interface was not up. I have some Questions: 1) As I'm deploying starlingX with only 1 controller & 1 compute Machine.while executing "sudo config_controller" it is taking the IP Addresses of controller 0, controller 1 & floating IP Address. As i have only one controller, So how can i avoid those type of configurations..? 2) Is there any specific installation guide for that(1 controller & 1 compute) type installation currently I'm following the guide: https://docs.starlingx.io/installation_guide/controller_storage.html#control.... Please suggest me the need full changes i have to done for that. 3) my controller machine have one Disk of around 3725GB, But when I'm trying to configure cinder on same disk host-disk-list command shows me available disk is as 0 GB. please suggest me if there anyway to use that same disk with cinder. snapshot of host-disk-list: [image.png] Regards, Himanshu Goyal On Thu, Jan 17, 2019 at 8:41 PM Alonso, Juan Carlos <juan.carlos.alonso@intel.com<mailto:juan.carlos.alonso@intel.com>> wrote: Hi, On what step of config_controller it is failing? Can you provide the logs? Are you deploying manually or automatic? To apply the config_controller again I think you need to start over the installation process. Regards. Juan Carlos Alonso From: Himanshu Goyal [mailto:himanshugoyal500@gmail.com<mailto:himanshugoyal500@gmail.com>] Sent: Thursday, January 17, 2019 7:22 AM To: starlingx-discuss@lists.starlingx.io<mailto:starlingx-discuss@lists.starlingx.io> Subject: Re: [Starlingx-discuss] Deployment Option Hi, I'm trying to install StarlingX Controller 0 on Physical Machine, But it is failing in config_controller at task waiting for service activation...... with Error: "Configuration failed: Timeout waiting for service enable" I'm using ISO available at the path: http://mirror.starlingx.cengn.ca/mirror/starlingx/centos/2018.10/20181110/ou... Please suggest us the procedure to debug that & how i can re-run the config_controller again. Many Thanks, Himanshu Goyal On Tue, Jan 1, 2019 at 3:34 PM Himanshu Goyal <himanshugoyal500@gmail.com<mailto:himanshugoyal500@gmail.com>> wrote: Hi, Can we deploy starlingX with 2 Machines 1 controller & 1 Compute Node (Both nodes on different physical Machines). Many Thanks, Himanshu Goyal
