Hello, Yes, now the commands are: $ system datanetwork-add physnet2 vlan $ system host-if-modify -m 1500 -n sriov0 -N 5 -c pci-sriov compute-0 eno1 $ system interface-datanetwork-assign compute-0 sriov0 physnet2 Then when I tried to create a network attached to physnet2, to create ports attached to this network I got the following error: controller-0:~$ openstack network create --mtu 1500 --provider-network-type vlan --provider-physical-network physnet2 sriov-net Error while executing command: BadRequestException: 400, Invalid input for operation: physical_network 'physnet2' unknown for VLAN provider network. I am not sure why this error, I create data network as vlan. Maybe should be a different type since it is created for SRIOV. Do you have any idea? Regards. Juan Carlos Alonso From: Legacy, Allain [mailto:Allain.Legacy@windriver.com] Sent: Tuesday, July 2, 2019 9:57 AM To: Alonso, Juan Carlos <juan.carlos.alonso@intel.com>; 'starlingx-discuss@lists.starlingx.io' <starlingx-discuss@lists.starlingx.io> Subject: RE: system host-if-modify error The commands related to creating and modifying interface was changed recently. Please refer to the mailing list post with subject: "Provisioning changes to host interface commands" which I have attached to this message. Regards, Allain Allain Legacy, Software Developer, Wind River direct 613.270.2279 fax 613.492.7870 skype allain.legacy 350 Terry Fox Drive, Suite 200, Ottawa, Ontario, K2K 2W5 [WIND]<http://www.windriver.com/> From: Alonso, Juan Carlos [mailto:juan.carlos.alonso@intel.com] Sent: Monday, July 01, 2019 10:14 AM To: 'starlingx-discuss@lists.starlingx.io' Subject: [Starlingx-discuss] system host-if-modify error Hi, I have been using the below command to set a SRIOV interface: $ system host-if-modify -m <MTU> -n <new interface name> -N <number of VFs> -p <data network> -c pci-sriov <host> <interface> $ system host-if-modify -m 1500 -n sriov1 -N 5 -p physnet0 -c pci-sriov compute-0 38922809-dec1-4e55-9f58-5db4b0859ae5 Command works correctly from ISO 20190627 and older. But now I got the following error: system: error: unrecognized arguments: -p 47569880-3225-4a96-b897-b7bf1d114b8d Seems that there is an error in the structure or syntax of command, but -p flag and interface UUID are separated by other parameters. I also try to use -d flag and interface name instead of uuid but got the same error. Do you know if this SRIOV command have changed? Regards. Juan Carlos Alonso