At a high level… Once the standby controller is installed and boots, it will run a set of tests, with a disabled/InTest state. Once the tests have completed successfully, the host will transition to Enabled/Degraded, while the DRBD filesystems sync (sudo drbd-overview). After the filesystems sync and everything is happy, the host will be Enabled/Available.

Cheers,

Don.

From: Rajesh Jha [mailto:Rajesh.Jha@rsystems.com]
Sent: Monday, November 19, 2018 1:51 AM
To: starlingx-discuss@lists.starlingx.io
Cc: Sumit Agarwal; Ajay Tomar
Subject: [Starlingx-discuss] Duplex Mode standby controller not coming up

Hi,

  On the latest iso from mirror

http://mirror.starlingx.cengn.ca/mirror/starlingx/centos/2018.10/20181110/outputs/iso/

When I run the Duplex mode, the standby controller is not coming up.  Its state is coming as inTest. Screen shot attached.

Best Regards,

Rajesh Jha

The information contained in this e-mail and any accompanying documents may contain information that is confidential or otherwise protected from disclosure. If you are not the intended recipient of this message, please immediately alert the sender by reply e-mail and then delete this message. Any dissemination, distribution or other use of the contents of this message by anyone other than the intended recipient is strictly prohibited. R Systems has taken every reasonable precaution to minimize the risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment.