[Starlingx-discuss] Question on N3000 firmware image upgrade
Hi - I'm looking at N3000 (Vistacreek) FPGA image management procedures supported by StarlingX as described in this link: https://docs.starlingx.io/configuration/intel_n3000_fpga.html. I have a couple of questions: 1. We usually run scripts to upgrade the FPGA in VC card. There are two binary images - one for BMC, and another the actual FPGA user image: bmc_fw_vista_rot_revd_19ww46.5_signed.bin sr_vista_rot_2x2x25g_19ww43.6_unsigned.bin The upgrade scripts work on these two images to upgrade the BMC firmware, and the FPGA image. 1. In the StarlingX image management procedure, there are commands given to upload the device image, Assign a device label to the device, Apply the device image on one or all supported devices. The question I have is: Can we separately repeat these steps for both images mentioned in point "1" (sr_vista image..., and bmc_fw image..)? 1. There is a statement in https://docs.starlingx.io/configuration/intel_n3000_fpga.html, which says - "The Intel FPGA PAC N3000 as shipped from the factory is expected to have production BMC and factory images. The following procedure describes how to update the user image on a host." Does this mean that StarlingX does not support BMC image update of N3000? Thanks, SSrini
SSrini, See my replies below. Bart From: Srinivas Sadagopan <Srinivas.Sadagopan@radisys.com> Sent: Monday, January 25, 2021 6:29 AM To: starlingx-discuss@lists.starlingx.io Subject: [Starlingx-discuss] Question on N3000 firmware image upgrade Hi - I'm looking at N3000 (Vistacreek) FPGA image management procedures supported by StarlingX as described in this link: https://docs.starlingx.io/configuration/intel_n3000_fpga.html. I have a couple of questions: 1. We usually run scripts to upgrade the FPGA in VC card. There are two binary images - one for BMC, and another the actual FPGA user image: bmc_fw_vista_rot_revd_19ww46.5_signed.bin sr_vista_rot_2x2x25g_19ww43.6_unsigned.bin The upgrade scripts work on these two images to upgrade the BMC firmware, and the FPGA image. 1. In the StarlingX image management procedure, there are commands given to upload the device image, Assign a device label to the device, Apply the device image on one or all supported devices. The question I have is: Can we separately repeat these steps for both images mentioned in point "1" (sr_vista image..., and bmc_fw image..)? [Bart] No. The starlingx procedure only supports updating the user image. 1. There is a statement in https://docs.starlingx.io/configuration/intel_n3000_fpga.html, which says - "The Intel FPGA PAC N3000 as shipped from the factory is expected to have production BMC and factory images. The following procedure describes how to update the user image on a host." Does this mean that StarlingX does not support BMC image update of N3000? [Bart] Correct Thanks, SSrini
participants (2)
-
Srinivas Sadagopan
-
Wensley, Barton