Hi Brent My bad, I did not put the controller-1 as unlocked, I updated my steps and added that as a prerequisite. It is working now controller-1 is taking the StarlingX deployment up and running and I can access to Horizon and CLI without problems. Regards, José

-----Original Message----- From: Rowsell, Brent [mailto:Brent.Rowsell@windriver.com] Sent: Thursday, October 4, 2018 4:24 PM To: Perez Carranza, Jose <jose.perez.carranza@intel.com>; starlingx- discuss@lists.starlingx.io Subject: RE: [Starlingx-discuss] Duplex behavior question

Assuming the other controller was unlocked/enabled at the time then no. Please open a Launchpad and attach the logs

Brent

-----Original Message----- From: Perez Carranza, Jose [mailto:jose.perez.carranza@intel.com] Sent: Thursday, October 4, 2018 5:18 PM To: starlingx-discuss@lists.starlingx.io Subject: [Starlingx-discuss] Duplex behavior question

Hi Folks

What is the expected behavior of a "duplex - two node redundant configuration" when the controller-0 is powered-off (physically powerd off)? current behavior is that Starlingx stops working cannot access the horizon and cannot execute commands on controller-1 due is not active. Is this one an expected behavior ?

Regards, José

_______________________________________________ Starlingx-discuss mailing list Starlingx-discuss@lists.starlingx.io http://lists.starlingx.io/cgi-bin/mailman/listinfo/starlingx-discuss