[Starlingx-discuss] unexpected behaviour in duplex mode in virtual env

Rajesh Jha Rajesh.Jha at rsystems.com
Thu Oct 25 10:10:45 UTC 2018


Hi,

We have observed an unstable behaviour while running below scenario

Setup- Virtual environment testing using kvm
Mode "Duplex" (One active and one standby controller script setup_allinone.sh)

Steps-

1. Followed steps in document "https://docs.starlingx.io/installation_guide/duplex.html#duplex"
2. Able to proceed till section "system host-unlock controller-0" command. After issuing this
command system get reboot as per expectation but once it comes up availability status
changed to "degrade" and alarm raised (screen shot attached).
3. Then we execute "destroy_allinone.sh" and "destroy_network.sh" command to cleanup the
previous setup to build new one
4. After following same step in above documents till "sudo config_controller" command
which was successful and after run "source /etc/nova/openrc" system get reboot again and
again and nothing happening after instead of rebooting. Screenshot is attached below.
CLI is no more available to the controller


Thank you,
Rajesh

The information contained in this e-mail and any accompanying documents may contain information that is confidential or otherwise protected from disclosure. If you are not the intended recipient of this message, please immediately alert the sender by reply e-mail and then delete this message. Any dissemination, distribution or other use of the contents of this message by anyone other than the intended recipient is strictly prohibited. R Systems has taken every reasonable precaution to minimize the risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment.



More information about the Starlingx-discuss mailing list