[Starlingx-discuss] Add OAM manually?

[Marcel Schaible]

Elio, thanks for sharing this valuable information.

Marcel

> "Martinez Monroy, Elio" <elio.martinez.monroy at intel.com> hat am 27. Februar 2019 um 01:54 geschrieben:
> 
> 
> Hello Yong and Marcel
> 
> Yes, OAM interfaces is set during config_controller.
> 
> And yes, you can modify OAM interface, please check following steps:
> 
> 1. In controller-0 (active), check default OAM config 
> system oam-show
> 2.Modify cEXT_OAM section with compatible configuration (OAM IP for controller-1)
> system oam-modify oam_c1_ip=10.10.10.11
> 3. Verify that new configuration is accepted
> system oam-show
> 4. Verify that config_applied ID is equal for all hosts
>    $ system host-show <host id>
> 5. Verify that config_target ID is equal for all hosts
> system host-show <host id>
> 6. Lock and unlock the controller-1, so config can be updated
> system host-lock controller-1
> system host-show
> system host-unlock controller-1
> system host-show
> 7. Swact controllers. Wait until new master (controller-1) controller appeared
> 8. verify that ip address for OAM interface is changed to new value and verify that oam controller IP address is changed to new address.
> ssh to host
> ifconfig (only for controllers)
> cat /etc/hosts
> 9. Verify that config_applied and config_target are equal to uuid of new applied config for new master host
> system host-show <new master host id>
> 10. lock and unlock the compute nodes one at a time, ensuring that sufficient resources are available to migrate any running instances
> 
> Please let me know if you have more questions
> 
> -----Original Message-----
> From: Hu, Yong [mailto:yong.hu at intel.com] 
> Sent: Tuesday, February 26, 2019 6:40 PM
> To: Marcel Schaible <marcel at schaible-consulting.de>; starlingx-discuss at lists.starlingx.io
> Subject: Re: [Starlingx-discuss] Add OAM manually?
> 
> Given you have at least 2 NIC interfaces for Controller-0, and One is for OAM and another for Mgt, OAM interface will be set by "config_controller", during which you can modify the IP address.
> After that, I am not aware changing OAM network is allowed.
> 
> Could you tell what you meant about *add manually the OAM interface*? 
>  
> -Yong
> 
> On 26/02/2019, 10:30 PM, "Marcel Schaible" <marcel at schaible-consulting.de> wrote:
> 
>     Hi,
>     
>     how can I add manually the OAM interface before unlocking controller-0?
>     
>     Thanks
>     
>     Marcel
>     
>     _______________________________________________
>     Starlingx-discuss mailing list
>     Starlingx-discuss at lists.starlingx.io
>     http://lists.starlingx.io/cgi-bin/mailman/listinfo/starlingx-discuss
>     
> 
> _______________________________________________
> Starlingx-discuss mailing list
> Starlingx-discuss at lists.starlingx.io
> http://lists.starlingx.io/cgi-bin/mailman/listinfo/starlingx-discuss