[Starlingx-discuss] R2.0 iso installation failure: USB device naming
ezpeerchen at gmail.com
Tue Sep 10 09:37:21 UTC 2019
I don't know the root cause. But i think this could workaround.
You should have two hard disk.
Go to the shell (ctrl+b+2) and use fdisk command to clear all your
partitions on your hard disks and create new clear partition.
Then use bootable usb to install STX again.
You can try it.
Pratik M. <pvmpublic at gmail.com> 於 2019年9月10日 週二 下午5:25寫道：
> The screenshot did not make it through since email exceeded mailer
> limit. Trying again.
> The error is "ERROR: Specified installation (sda) or boot (sda) device
> is a USB drive."
> Thanks in advance
> On Tue, Sep 10, 2019 at 2:30 PM Ezpeer Chen <ezpeerchen at gmail.com> wrote:
> > Dear Pratik,
> > I can't see your screenshot .
> > What's your installation issue now ?
> > Best regards,
> > Pratik M. <pvmpublic at gmail.com> 於 2019年9月10日 週二 下午4:40寫道：
> >> [re-sending since the previous message exceeded msg-size]
> >> Hi,
> >> I cannot seem to install the STX R2 iso using a USB key, since the
> >> SATA device naming on my server ends up assigning /dev/sda to the USB
> >> key (screenshot attached). And I believe the installer assumes the
> >> root device as /dev/sda.
> >> I tried both legacy and UEFI boot.
> >> Also what is the way to get to a root shell during the ananconda
> >> install? tty2 has a login prompt. I tried sysadmin/root with
> >> sysadmin/St8rlingX* combinations, to no avail.
> >> Thanks in advance
> >> Pratik
> >> _______________________________________________
> >> Starlingx-discuss mailing list
> >> Starlingx-discuss at lists.starlingx.io
> >> http://lists.starlingx.io/cgi-bin/mailman/listinfo/starlingx-discuss
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Starlingx-discuss