[Starlingx-discuss] controller-1 install/setup using ISO (not pxe)

[Penney, Don]

Only the first controller can install from ISO. All other nodes must install from the active controller via pxeboot.

-----Original Message-----
From: Pratik M. [mailto:pvmpublic at gmail.com] 
Sent: Thursday, September 19, 2019 4:59 AM
To: starlingx-discuss at lists.starlingx.io
Subject: [Starlingx-discuss] controller-1 install/setup using ISO (not pxe)

Hi,
I have installed controller-0 and my OAM_IF is eno1 and MGMT_IF is
eno2. I am trying to install controller-1. However, my existing OAM
lab network already runs pxe. And my server BIOS does not have an
option to select one specific network interface for PXE booting.

So I tried to temporarily switch the cables (connect mgmt to eno1 and
disconnect oam). The pxe boot works; controller-1 gets discovered. And
I can do host-update 2 personality=controller. After the install and
reboot, I switch back the cables. And try to set the OAM_IF to the
correct/final interface (eno1).
[sysadmin at controller-0 etc(keystone_admin)]$ OAM_IF=eno1 && MGMT_IF=eno2
[sysadmin at controller-0 etc(keystone_admin)]$ system host-if-modify
controller-1 $OAM_IF -c platform
Interface not found: host controller-1 if eno1

I see the controller-1 does not have an IP post reboot. I tried
manually setting the eno2 IP to 192.168.204.2/24 but still it shows
offline.

[sysadmin at controller-0 ~(keystone_admin)]$ system host-list
+----+--------------+-------------+----------------+-------------+--------------+
| id | hostname     | personality | administrative | operational |
availability |
+----+--------------+-------------+----------------+-------------+--------------+
| 1  | controller-0 | controller  | unlocked       | enabled     |
available    |
| 2  | controller-1 | controller  | locked         | disabled    |
offline      |
+----+--------------+-------------+----------------+-------------+--------------+

I cannot reverse the cabling on the NICs for a different set of reasons.

Any workaround? Is there a way to install the software using iso, set
some IPs manually and then enroll the controller-1 to the cluster?

Thanks in advance
Pratik

_______________________________________________
Starlingx-discuss mailing list
Starlingx-discuss at lists.starlingx.io
http://lists.starlingx.io/cgi-bin/mailman/listinfo/starlingx-discuss